Hi Colleagues,
I have been looking around on how to increase a log area or log volume but I have not been seeing a direct answer to that. Is this not possible but the only way is to add a log volume?
I am installing a SAP Content Server with a MaxDB as a storage system and per Content Server sizing the log volume must be 10% of the data volume as per below statement:
On average, how many users are likely to access the content server at any one time?
The goal here is to ensure that the transaction buffer is sufficiently large to allow a number of users to access the content server simultaneously. To this end, the log volume should be approximately 10% of the calculated data volume. In all cases, it should be at least twice the size of the largest expected document. This is so that the content server can handle at least two simultaneous accesses.
Also, in the installation tool at the screen where it asks for the following:
Content Server Data Size [MB]
That specific input field is already asking for the total expected data area size or storage right? For specifying this field, how does it impact the succeeding installation prompts or values? Can it be changed later on?
Regards.
Jennah